Well, i’m using Kraken X60 water cooling system in my current 2011-v3 RIG with all that shiny stuff launched in september 2014, but initially i did use the “Kraken Controls” Software to configure and adjust my water cooling system.
When i installed the hardware and Kraken Controls these days, they had another software available to manage your cooling system. It’s called “CAM” or “Kraken CAM” and was at version 1.1.2, if i remember correctly.
Kraken LED when system powered off
If you want your LED flavoured Kraken/Watercooling Heatsink to not glow when the system is powered off, change the ErP Setting in the BIOS to “S4 + S5”.
Kraken CAM version 1.1.2 to 1.1.7
However the Kraken CAM version that was available didn’t work well with my new Intel i7-5930K and the Asus x99 Deluxe motherboard. The CPU temperature couldn’t be read by the software, like it can’t be read by Kraken Controls (see picture above: no CPU temperature) and the overall look and feel did remind me too much of Windows 8.x. So i sticked to Kraken Controls only and kept using it. Now, a month later, i gave it another try. The version of Kraken CAM is currently 1.1.7 and the CPU temperature is now being read by the software (picture below).
CPU temperature display not the only improvement?
The Kraken CAM software takes way more time to start than the Kraken Controls, which is a downside, but this will not be the point here. What i noticed first was, that it seeeeems to make my water cooling system run a lot smoother or lets say fluent :). The fans do not spin up that much like they did before at almost equal temperatures results. Yes, there will be a difference in the fan curves between Controls and CAM, but the point are the temperatures. That can only mean, that the pump is being used more efficiently.
Chose Kraken CAM
No matter what they did here, i write this post to just recommend you using the Kraken CAM software instead of Kraken Controls! I also doubt that they will put further development on the Kraken Controls software.